View Single Post
Old 11-19-2011, 08:21 PM
Lumbergh's Avatar
Lumbergh Lumbergh is offline
MC Fanatic
Join Date: Aug 2011
Boat: 1991 ProStar 190
Location: Seattle
Posts: 806
@ mgorczak1:

The bad hose was the muffler to exhaust flange hose (3" x 3'). So to truly satisfy your OCD, your gonna have to pull floor panel behind the engine dog house and undo the 4 hose camps (each side and pull hoses).

Think of it as an opportunity to clean the aft bilge, lube your rudder assembly, and inspect the aft portion of the blower hose.

I found the battery terminal covers back there while I was working, slid them back up onto battery. Also rerouted the shower hose up against the hull instead of against the muffler.

Sorry to be an enabler.

But now you have me thinking that I should pull my starboard riser and put new bolts and gasket just to match the great looking hardware on the port side previously done in the past few months. Yours looks so clean and will look great once you reassemble with new hardware.

Last edited by Lumbergh; 11-20-2011 at 01:02 AM.
Reply With Quote