View Single Post
Old 07-13-2012, 06:18 PM
mcparadise's Avatar
mcparadise mcparadise is offline
TT Enthusiast
Join Date: Jun 2012
Boat: 1998 Sportstar 19/305 Chevy Indmar (4160 Carbed)
Location: Hawaii
Posts: 177
Originally Posted by SugarLake View Post
Getting frustrated and looking for ideas. Boat is an '88 PS 190 with 351 and brand new (last year) Holley 4160. Boat was running fine but I decided to replace the power valve with a 2.5 because I wasn't sure what the new carb came with and I was having some slight bogging and rich smell out of the hole. Pulled the front bowl, switched out the power valve, put it back together and it wouldn't start. Finally figured out it was getting way too much gas and got it to start with choke open and wide open throttle. If I back off the throttle it will stay running for a while (with black smoke) but quickly loads up.

I pulled the front bowl again, blew through the float and it seemed to be shutting off fine. Tried again with same results. Then I pulled both bowls, blew through the inlets with compressed air, checked them both to see that the needles and seat were closing by holding them upside down and blowing through the inlets with my mouth. Seemed to be working fine. Put it back together and still have the issue. I also tried changing back to the original power valve.

What did I do? Doesn't make any sense to me.
For what it my be worth, I had a "similar" problem in my 98 regular-carbed SS19 with Indmar 305that kicked my mechanic's butt. Nothing worked. Holly 4160 650 cfm was fine and almost new....end of story is the Carter fuel pump (high volume low pressure) was putting out way too much pressure and flooding her out. At that time I had no pressure gage, no longer though !, so it was hard to disgnose. I went with the marine Holly instead which mounts with terminals on top not on bottom (poor Carter design in my book considering they are "press fit" with a screwy wire retainer).
Reply With Quote