|
#1
07-25-2013, 01:25 PM
|
||||
|
||||
|
Anyone know where I can get an exhaust manifold gasket quick
I have blown out the exhaust manifold I just had put on. It must be something stupid like it wasn't tight enough or something.
I have to replace the gasket and I can't drive it the way it is and am trying to save the weekend. Anyone know where I can get a port side exhaust manifold gasket 1995 Indmar Thanks
__________________
 When I was a child, I used to talk as a child, think as a child, reason as a child; when I became a man, I put aside childish things.
1 Corinthians Chapter 13 - 11 
|
|
#3
07-25-2013, 01:58 PM
|
||||
|
||||
|
Thats what I put on before. I want a little better one this time i think.
__________________
When I was a child, I used to talk as a child, think as a child, reason as a child; when I became a man, I put aside childish things.
1 Corinthians Chapter 13 - 11
|
|
#4
07-25-2013, 02:05 PM
|
||||
|
||||
|
Quote:
__________________
 Ayyyy!2004 Red/White/Black something or other.  Formally, 1994 RED Mastercraft 205, Chevy 5.7 TBI.
|
|
#5
07-25-2013, 02:09 PM
|
||||
|
||||
|
Really, RTV thats it.
What directions 
__________________
When I was a child, I used to talk as a child, think as a child, reason as a child; when I became a man, I put aside childish things.
1 Corinthians Chapter 13 - 11
|
|
#6
07-25-2013, 02:25 PM
|
||||
|
||||
|
__________________
CUSTOM WHEEL & TIRE PACKAGES  $125 LED LIGHT PACKAGE - FREE SHIPPING REBUILDING HOLLEY MARINE CARBS - $249 DELIVERED REBUILT COMPLETE MARINE HOLLEY 4160 CARBS FOR 302, 351 & 454 STARTING AT $425 DELIVERED Email - tiresplease@gmail.com
|
|
#7
07-25-2013, 02:50 PM
|
|||
|
|||
|
Cut one!
|
|
#8
07-25-2013, 03:09 PM
|
||||
|
||||
|
I wouldn't use anything on the bolts. If anything, chase the threads down with a bottom tap and clean the blots with a hand held wire brush. Be sure the make sure the mounting seats and cheeks of the bolts are clean too.
Loctite is a is definite no no on exhaust bolts/studs.
__________________
Tim
|
|
#9
07-25-2013, 04:13 PM
|
|||
|
|||
|
Quote:
|
|
#10
07-25-2013, 04:18 PM
|
||||
|
||||
|
Get some good gasket material and make one. Very easy just place on top of manifold surface and rub head of a hammer around the internal & external edges and it will leave an outline of where to cut it.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
waiting for another
Linear Mode
