Go Back   TeamTalk > Maintenance Tips, How-tos and Refurbishing Topics > Engine / Drive Train

Reply
 
Thread Tools Display Modes
  #1  
Old 07-07-2013, 05:39 PM
trayson trayson is offline
TT Newbie
 
Join Date: Jul 2013
Boat: 1992 Supra Sunsport
Location: Northwest
Posts: 9
special tools for a PCM 40i 1:1 tranny rebuild? Also tips/tricks?

So, I pulled my tranny Friday. it had been slipping and losing about 1/4 of a quart of fluid in 4 hours of use. Friday I ended up sucking water into the tranny and milkshaked the fluid. so I am buying a seal kit and figure a rebuild makes sense as it is 530 hours anyway...I was able to find the service manual for the PCM40a, and it referenced some special pullers. does anyone know about these? are they needed? if so where to get and how much do they cost? Any tips and tricks are very welcome--I will have the help of a very experienced ford car service tech... but any insight into the boat tranny will be great.

Now you see it...


Now you don't:
Reply With Quote
  #2  
Old 07-07-2013, 05:55 PM
trayson trayson is offline
TT Newbie
 
Join Date: Jul 2013
Boat: 1992 Supra Sunsport
Location: Northwest
Posts: 9
Here are the special tools referenced in the 40a service manual (yes, I know I have a 40i, but it's the closest I could find online).











Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -4. The time now is 07:09 PM.