Show Us Your Custom Boat Parts!

[02ProstarSammyD]

^where'd you get the material? I'm in the middle of doing the 3m stuff over mine b/c I couldn't find the dash pieces

[prostar205]

Originally Posted by 02ProstarSammyD

^where'd you get the material? I'm in the middle of doing the 3m stuff over mine b/c I couldn't find the dash pieces

Just do a search for "engine turned material". I got mine from FMP metals (www.fmpmetals.com).

I did have to bond it to a .90-inch thick piece of aluminum. I think the engine turned material only comes in up to .62-inches thick. Get the 3/4-inch swirl pattern. Mine is the 1/2-inch swirl pattern and it's a little smaller than the stock material.

[CC2MC]

@TPH, That is pretty cool about the "rooster reducer", but tell me more about that custom swim platform. Nobody seemed to mention this yet.

[GoneBoatN]

Originally Posted by 02ProstarSammyD

... I've been banned from boat work until the "house is family ready"...

Originally Posted by thatsmrmastercraft

My family would never ban me from the boat. They know I'm hopeless when it comes to the boat. It's good to be understood.

[Ben]

Originally Posted by tph

It probably works as well as the '86-'90 hull. That portion of the wake seems lower and softer. I don't have any "before" pictures but here is a picture from October of this year @ approximately 32-34 MPH. (sorry, it's a cropped smartphone picture)

Metal flake looks badass. Nice ride.

[mikeg205]

Originally Posted by GoneBoatN

My family would never ban me from the boat. They know I'm hopeless when it comes to the boat. It's good to be understood.

you're not alone ...

[ZachDaddy]

I dont remember where I got them. I have one more if your interested as I bought three to use on my Moomba.

[tph]

Originally Posted by CC2MC

@TPH, That is pretty cool about the "rooster reducer", but tell me more about that custom swim platform. Nobody seemed to mention this yet.

I love the look and durability of teak but practically speaking, a carpeted oversized platform is the way to go. It's not the prettiest thing out there but it's great to easily put your ski or board on and slip into the water off the edge. Here are some pictures:

[SWGA Boater]

Originally Posted by CantRepeat

Some carbon fiber dash panels I made for my 92.

Looks great. Were these CF panels cut to fit or did you use a wrap?

[SkiDog]

I was asked about posting a pic of the finished product after it was installed. Here ya go. If you wanted to actually sit on it, then I would put in stainless cup holders.