Go Back   TeamTalk > Maintenance Tips, How-tos and Refurbishing Topics > General / Other

Thread Tools Display Modes
Old 11-19-2012, 05:15 PM
3orange1blue 3orange1blue is offline
TT Newbie
Join Date: Nov 2012
Boat: Mastercraft, x-2, 2004, MCX
Location: Northwest
Posts: 1
2004 X-2 Factory Shower Pump Location

I'm installing a shower on my 2004 X-2. I have had great luck locating the locations for factory installed options, such as the stiffened sections of the hull for the cleats, but I'm not sure where the factory puts the pump for the shower.

If anybody has one and can go take a peek, or can send me a reference, I'd greatly appreciate it.


Last edited by 3orange1blue; 11-19-2012 at 05:18 PM.
Reply With Quote
Old 11-19-2012, 06:56 PM
GoneBoatN's Avatar
GoneBoatN GoneBoatN is offline
MC Maniac
Join Date: Oct 2010
Boat: 2010 X-15 w/MCX
Location: Nor Cal
Posts: 3,007
Picture is of the starboard side compartment next to engine. You can see the shower/slickBoot on/off switch on the left and shower control knob on the right. It is a plastic sheet that has been covered with grey carpet. The shower pump is mounted on the reverse side. You can see two screws that go through the fiberglass on the top and there is another screw on the lower right that you can not see because it is near the bottom of the bilge - actually right above the fiberglass stringer that runs the length of the hull. This is a 2010 X-15 factory install. You can also see the cold (blue) and hot (red) water lines because I have the panel that separates the hold from the engine compartment removed.
Attached Images
Reply With Quote

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -4. The time now is 07:53 AM.