Ballast pump bearing size

[76S&S]

I was in the process of refreshing one of my pumps and the bearing is getting a little noisy. Does anyone know what size it is?

I was looking on the page below but don't know the size.

http://www.jabscoimpeller.com/jabsco...ngs-s/1829.htm

[CantRepeat]

Not sure of the size, but the only one that looks like bearing used in the ballast puppy pump is this one.

http://www.jabscoimpeller.com/jabsco...p2601-0457.htm

At 5 bucks it's worth a try.

[76S&S]

Cool, for $5 bucks I ordered one yesterday just to see if it might be the right one.

[TReece]

Any luck rebuilding pump?

I have one going out!

[mallees]

Originally Posted by CantRepeat

Not sure of the size, but the only one that looks like bearing used in the ballast puppy pump is this one.

http://www.jabscoimpeller.com/jabsco...p2601-0457.htm

At 5 bucks it's worth a try.

I don't think that is the right bearing, It looks like a 6001

I rebuilt a Jabsco ballast pump a few years ago, and when i bought the bearings, i had to get a few extras to make up a minimum order value.
I still have 1 sitting in my drawer NSK part# is 627z. Now it was several years ago, but I'm pretty sure this is the correct bearing. Only cost me about $3 each if i remember correctly. I assume you have stores in the States that specialize in bearings and seals. Bearing dimensions are:
22mm od
7mm id
7mm thickness.

[CantRepeat]

Well if that is the correct part number its still pretty cheap.

http://www.amazon.com/industrial-sci.../dp/B007Z2WSY2

[bturner2]

Well the review on Amazon wasn't the greatest for that part. Shipping is $9.95 so one bearing is $20 and 2 would be $30 (shipped) which is the price I recalled. The review pretty much sealed the deal for me on not going with this part.

Ordered two bearings, made in Indonesia, received them 1 day apart costing me 2x shipping... , the bearing fell apart after 3 days of use, hopefully my second one lasts longer.. I don't want to keep replacing these for my motor. Original bearings in my motor.. lasted 10+ years..

[CantRepeat]

I found a guy selling them for 12 for 10 bucks. Said he didn't know what they went to so figured I'd take a chance on them.

Here's 8 for 9 bucks.

http://www.ebay.com/itm/New-Peer-rol...71091775809%26


I'm not sure if they are the correct size but I'll let you know when I get them.

[mallees]

Most common cause of early bearing failure is bad installation technique. I would try to find a local industrial supplier that stocks bearings. These should be off the shelf for around $5-$10.

[bturner2]

That's what I did with the place in Grand Rapids MI. No luck there. If someone can find something that works I have two pumps that need bearings and two pump housings that need seals. Would love to rebuild them as spares.