header |
|
#1
10-02-2011, 09:20 AM
|
|||
|
|||
|
Rudder/Tiller Arm
I have a question about the steering connection to the rudder tiller arm. I was adding grease to the rudder box and noticed the bolt connecting the steering cable to the tiller arm was loose. I could spin the bolt freely. Is this correct? Or should this bolt be snug/tight?
|
|
#2
10-04-2011, 02:05 PM
|
||||
|
||||
|
On my 2005 PS197, both steering cable/rudder arm bolts & nylon locking nuts are snug...the bolts do not spin/rotate by hand. However, the bolts/nuts are not too tight to prevent the bolts/rudder arm to swivel as necessary when the steering wheel is turned...mac
__________________
2005 ProStar 197TT, #31/100; Tournament PB 1.5 @ 38 off, June 2012
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
