1996 Pro Star Restoroation - Another winter project

[Worthing skier]

Originally Posted by Table Rocker

Okay, I went out to the boat and took my ('96) dash apart to see if I could find some answers for you.

On the back of the lanyard switch two purple wires come out and go into a small (pencil sized) loom. This loom goes up to the dash behind the speedometers. One of the purple wires goes down to the ignition switch and the other purple wire takes a 180 degree turn and goes into the large loom that heads for the engine. I looked at the ecm and found a purple wire there. No relays are behind my ignition switch.

It looks like the best way to bypass the lanyard switch would be to take the wire going into the bigger loom and connect it to the ignition switch.

If you have any questions, let me know soon while I still have it apart.

Good luck.

Hello


Many thanks for your help and the info ,
as I thought ,the relays are not a standard fitment ,
I think they were to do with boat previously being run on Gas (or LPG in the USA)
will remove them and re wire the kill switch circuit ..

rgds

Kevin

[Table Rocker]

Originally Posted by Worthing skier

Hello


Many thanks for your help and the info ,
as I thought ,the relays are not a standard fitment ,
I think they were to do with boat previously being run on Gas (or LPG in the USA)
will remove them and re wire the kill switch circuit ..

rgds

Kevin

Glad to help. Let me know if you need anything else. I still have the panel off.

[Worthing skier]

Had the ski pole polished at a local metal polisher ,
It has come out with a near chrome finish ,
not too sure on its finish as I prefer the mat alloy look, but it has remove lots of marks.

Has anyone ever bought the plastic insert on the top of the pole ?

thanks


Kevin

[Snipe]

Is it hard to get out??

[Worthing skier]

Originally Posted by Snipe

Is it hard to get out??

No , it is just a allen bolt in the top of the pole .
Have not tried to undo it yet , will do once the pole is fixed back in the boat .

[Worthing skier]

Well its been a few weeks of not a lot going on ,
hope to get the block back very soon ,
Does any of you kind people know the torque settings for the big ends, mains and head bolts .

Many thanks in advance

Kevin

[supturb89]

Any updates?

[nkorep2]

They should be near 90-120 ft/lbs

[Worthing skier]

Hi there


Thanks for the interest ,
still waiting on getting the block back , it is been done at "Mates Rates" so I have to be patient , should not be too much longer .
Anyway the sun has now come out and its a bit warmer here so I am skiing with the 1993 Prostar at the moment .

Will post as soon as the block is back

rgds

Kevin

[sd209]

any new updates?