Zero Flex Tower rubber mounting pads?

[M-Funf]

Guys,
Bad news. My molds have now deteriorated to the point that I can no longer mold an acceptable set of pads. I have been molding all week, and they are just not up to the task.
To make new molds is very expensive, and I don't have the orders to cover the cost of the molds and materials, so for the moment I'm out of the tower pad business.
That said, I hope to change that in the near future, and may be in a position to order molds again. When I get there, I'll reach out again to gauge interest. If there's enough interest to cover the cost of the molds, I can take the risk and order a set to continue.

I didn't start making these to make money. I started this to help out a buddy who had crappy tower pads. It was a fun project, and from the start I said as long as I don't lose money (just my own time), I'd continue to make them. It's just not the best time right now.

Jeff.

[JohnnyB]

No worries! Thanks

Sent from my PB99400 using Tapatalk

[nickespi]

That's unfortunate. I'm first on the list when you are able to get back up.

[kal_dude]

i would take a set also if its money you seek, i can show you how to make that

[SpryBeast]

Interested as well.

[Maddmax]

Did those boots work out for your tower? I can use some new ones, mine keep coming around a little bit.

[Mgboyd25]

I needsome too!!! Just came accross this thread or else I would have ordered earlier

[aswile]

Thanks for taking the time to make them- I wish I had taken you up on a set earlier. If you decide to make more, count me in!

Andy

[cwarndahl]

i was just coming back to this thread to PM you. ha if it changes let us all know!