Go Back   TeamTalk > Maintenance Tips, How-tos and Refurbishing Topics > Engine / Drive Train

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #11  
Old 07-26-2013, 07:55 PM
j.mccreight@hotmail.com's Avatar
j.mccreight@hotmail.com j.mccreight@hotmail.com is offline
MC Maniac
 
Join Date: May 2010
Boat: 1989 MasterCraft TriStar 190 SE
Location: Houston, TX
Posts: 3,133
Ok look here's the deal if you have a bone stock intake manifold with the original carburetor spacer you install the vavuum gauge into the port on the spacer, and just leave the PCV valve open for the duration of the test, there is no need to remove the rear port that is plugged with an allen bolt. If you replaced your intake manifold with a edelbrock or weiand you likely installed a port for your pcv already if you didn't reuse the factory carburetor spacer, if the spacer was reused than again use that port. Some later carburetor's had a manifold vacuum port that was plugged if your carburetor has this port use it. Many ways to get manifold vacuum, but by far the easiest way is to go through existing pcv port
Attached Images
   
__________________
James

1989 MasterCraft TriStar 190 SE
Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -4. The time now is 04:33 AM.