What Work did you do on your Mastercraft Today?

[76S&S]

Dropped her off at Viper Customs for a new interior. Looked at some of their recently finished boats and man do they do great work!

[walterlaughlin]

Originally Posted by Snipe

Nice looking job. Very clean.Great to have your daughter involved it's important to see them feeling needed. I do that with my grand kids too. BTW what kind of waterproof glue did you use? Don't forget to remove the tape.

I didn't use any glue, that's what the blue tape is for! Just kidding, the pad came with an adhesive on the bottom that is really strong. I put the pad in place, patted it down for a few mins, and it was good to go! Loving the non-slip feel of the material, just enough thickness to be a little soft on your arse but not thick enough to feel spongy. Two thumbs up!

[monsterwake]

Originally Posted by JDC

Got a picture of the switch? If it's what I'm thinking, and it's like mine (Carling Technologies), you have to replace the switch. The bulb is made in with the switch (not replaceable).

I will get one. It looks like I will need to replace the switch.

[SkiDaddy]

Well, this last weekend, I cleaned up the bilge a little, disconnected the steering cable and cleaned it up, greased the steering cable ball joint connection, and sucked out the tranny fluid and refilled. I am ready for spring........next warm weekend day we get, she's going out of the garage and getting started...we'll then see how my winter carb rebuild worked out!!!

[TxsRiverRat]

i got my back seat yesterday! My upholstery overhaul is complete!

The lady cut the seat into 3 sections, and the center cushion is a slight wedge shape to keep it better in place...

[thatsmrmastercraft]

Originally Posted by TxsRiverRat

i got my back seat yesterday! My upholstery overhaul is complete!

The lady cut the seat into 3 sections, and the center cushion is a slight wedge shape to keep it better in place...

Nice. Enjoy breaking it in.

[SkiDaddy]

Hey RiverRat - I like that middle section....makes a nice step when you remove the padded middle section!

[texasjet]

Looks great. Will make for a fun summer.

[pram]

that looks fantastic

Are you concerned about the breakdown of the seat itself with people stepping on it?

I think that I remember that it was just plastic the seat base?

[TxsRiverRat]

Originally Posted by SkiDaddy

Hey RiverRat - I like that middle section....makes a nice step when you remove the padded middle section!

yes, it does, complete with nonskid surface. Now all I need is a soap caddy for the transom.

Originally Posted by texasjet

Looks great. Will make for a fun summer.

Thanks! I can’t wait to get the season started!

Originally Posted by pram

that looks fantastic

Are you concerned about the breakdown of the seat itself with people stepping on it?

I think that I remember that it was just plastic the seat base?

Thanks! Yeah I was, that’s why I had it modded to be a 3 piece as opposed to a single. While skiing, we’ll remove that center section and theres a spot to step over.

Been a lot of years since the rear seat was in there, I forgot how small the interior of that boat was until I was in it last night...