What Work did you do on your Mastercraft Today?

[JRW160]

Originally Posted by gusolah

Is there a trick to getting impeller out of ilmor 6.0? Can't seem to pull it out of housing.

Make one of these
http://mastercraft.com/teamtalk/show...88&postcount=2

[Rockman]

Received the replacement slat for the platform this week...started on cleaning the driver seat which was pretty dirty...nothing else to report but it being 22 degrees F out today.

[SP Maristar]

Installed new trailer guide pole covers. Pulled the cover back and sat inside for a few minutes. Didn't make boat noises, but thought about it.

[mikeg205]

Originally Posted by Rockman

Received the replacement slat for the platform this week...started on cleaning the driver seat which was pretty dirty...nothing else to report but it being 22 degrees F out today.

and the river is 34 degrees...

[monsterwake]

Mounted and wired my amp. Still deciding on tower speakers.

[02ProstarSammyD]

drove 800 miles yesterday to pick up boat skins lol

[Rockman]

Originally Posted by mikeg205

and the river is 34 degrees...

I had to help a friend move a big old tv yesterday afternoon and by the time I got the C clamps off the truck holding the fiberglass cap on, with the impact, my hands were numb...I think it said 20 degrees in the rear view mirror but the wind chill was terrible...

Sorry Mike, indoor sports for at least another week!

[Rockman]

Originally Posted by 02ProstarSammyD

drove 800 miles yesterday to pick up boat skins lol

FedEx???

[strad]

Ran it out on the lake today. Discovered that one valve cover gasket is still leaking even after replacement I did torque it down pretty good too and cleaned the surfaces, so I don't know what its excuse is. Was nice to have it out again for the first time in three months though.

Picked up all this trash within about a 1 mile span in the lake. Litterbugs are annoying!

[Juiced190]

Originally Posted by Rockman

Received the replacement slat for the platform this week...started on cleaning the driver seat which was pretty dirty...nothing else to report but it being 22 degrees F out today.

Rockman, where did you get the replacement slat? I have a slat missing on my 96 190? Thanks