Go Back   TeamTalk > General MasterCraft Topics > General Discussion

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #11  
Old 02-04-2013, 06:52 PM
Kweisner's Avatar
Kweisner Kweisner is offline
TT Enthusiast
 
Join Date: Oct 2012
Boat: 2007 Prostar 197
Location: Southeast
Posts: 400
Pix and Thanks Again

Okay guys--I'm not an expert at this so bear with me. Also, shooting photos under the dash with all the spaghetti made for some tricky lighting.

First, modified the batter cover a la Sodar's install:


Then, ran custom terminated wiring (did my own but I have a tool just for compressing lugs onto cable--2 Gauge in this case.


Here's one part of the install that I could use some other ideas on. Currently, the wires to the House Batt/Isolator run forward from the starting battery and then through the cutout for the heater duct. I did sleeve the cable in plastic loom so that the fiberglass edge of the heater access cutouts won't damage the softer insulation on the cable. Any ideas of alternate routes?

At any rate, here's the isolator as suggested by Diesel--mounted on the bulkhead near the other electrical bus bars. Positive in/out secured with nylocks. Signal cable tied to the ignition key and ground for relay activation:



And finally, the overkill billet holder and streetwire clamp (ground side shown). A bear to get it in there and I will be adding a battery maintainer for just this unit--taking Sodar's sage advice so that I don't have to wrestle that thing much:

__________________
"This one goes to eleven." 2007 ProStar 197 TT w/MCX and Powerslot.
Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -4. The time now is 03:33 AM.