Through Hull Placement

[CantRepeat]

Originally Posted by jfw432

If you can drill it, you can plug it. Sack up and go for it.

If you decide later, you don't want the pickup anymore, we can help you restore it back to the way it was.

Who are "we" that you are talking about?

Rather then "sack up" I'd suggest the old measure twice and drill once.

[jfw432]

"We" meaning the forum. If "we" isn't willing, I will certainly give advice on how to repair screw ups. I'm sure you'll be fine though. Look for an open flat spot just off centerline between the engines water inlet and the place where the driveshaft goes through the hull. One you've decided on a spot, look under the hull and make sure it truly is open.

[CantRepeat]

You can check out this post for some help in installing your through hull.

http://www.mastercraft.com/teamtalk/...d.php?p=898344

[dihrdskir]

Originally Posted by CantRepeat

You can check out this post for some help in installing your through hull.

http://www.mastercraft.com/teamtalk/...d.php?p=898344

Perfect. This is exactly what i have been looking for. Thanks Cant Repeat.