#41
|
||||
|
||||
I think he meant "ignition switch". You can get one at your MC dealer if you want it to be original. I replaced mine since it had a cheap aftermarket style in it, and the new switch was about $40 IIRC. 2 keys came with mine.
You might want to try a bit of spray lube first. The lock tumblers can get moisture, dirt etc. in it and a little lube might just do the trick. Just a short squirt in the hole (don't flood it), or you can spray the key and insert it in the lock hole, doing that 2-3 times.
__________________
Jeff Last edited by JDC; 11-03-2012 at 09:17 AM. |
#42
|
||||
|
||||
Ok, I'll try some lube first.
My dad is pretty sure that shaft is straight, but the strut is probably bent. Has anyone repaired/straightened one if it has a slight bend? Also, the shaft has a couple spots that show some wear (you can feel it with your finger). Do people re-condition it, just use it, or get a new one? |
#43
|
|||
|
|||
[quote
|
#44
|
|||
|
|||
Quote:
|
#45
|
||||
|
||||
No comment...
Anyone else? Or am I just going to have to make some calls to local shops?... Anyone gotten work done by Propulsion Inc.? (Propfix.com) |
#46
|
||||
|
||||
Well I've gotten a few quotes on upholstery. Viper so far is the cheapest, but I'm still waiting on a reply from Jim the upholstery guy. I hope to get the shaft and prop dropped off this weekend if I have time. When we test rode it, it seemed to run sluggish and on the rich side. Where can I find a cheap carb rebuild kit?
|
#47
|
||||
|
||||
Quote:
New shaft from skidim, refurbished prop, some glass work, and I was good to go.
__________________
Previous: 1993 Prostar 205 Red 1998 Ski Nautique, PCM GT40, 310 hp, , Acme 4 blade, Perfect Pass SG/Zbox. FAQ Be kind. Have fun. |
#48
|
||||
|
||||
Quote:
Holley 4160 Rebuild Kit for 351, etc.
__________________
Previous: 1993 Prostar 205 Red 1998 Ski Nautique, PCM GT40, 310 hp, , Acme 4 blade, Perfect Pass SG/Zbox. FAQ Be kind. Have fun. |
#49
|
||||
|
||||
Quote:
http://www.summitracing.com/search/p...tor-model/4160 Here's a couple tools we made for removing/installing the prop shaft nut/hub: ![]() Removed some material in the socket to make room for the radius on the nut. ![]() |
#50
|
||||
|
||||
Quote:
nicely done...
__________________
![]() |
![]() |
Tags |
1991 ps 190, mastercraft, prostar 190 |
Thread Tools | |
Display Modes | |
|
|