Go Back   TeamTalk > General MasterCraft Topics > General Discussion

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #11  
Old 05-28-2009, 01:57 AM
Bellinghamster's Avatar
Bellinghamster Bellinghamster is offline
TT Enthusiast
 
Join Date: Apr 2008
Boat: 1978 Stars and Stripes, PCM 351 (60hrs)
Location: Northwest WA
Posts: 175
My first time out this season I heard squealing while idling away from the launch, shut down to investigate - the raw water pump was too hot to touch! It failed to prime due in part to the hose loop above waterline out of the transmission cooler, and possible because I'd drained the block and the heater hoses - I've got a "T" heater return to the suction side of the raw water pump. With the block empty it was pulling air from the block/exhaust backwards through the heater and into the intake of the water pump. I swapped impellers (for good measure), poured water into the hoses to fill them up, pinched off the heater circuit hose and fired back up - no problem. I should have run it on a garden hose first to fill everything up with water before launching...
Reply With Quote
 

Tags
engine, impeller, overheat, temperature, wakeboarding

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -4. The time now is 11:45 AM.