Go Back   TeamTalk > Maintenance Tips, How-tos and Refurbishing Topics > General / Other

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #1  
Old 07-08-2008, 06:58 PM
Roonie's's Avatar
Roonie's Roonie's is offline
MC Devotee
 
Join Date: Sep 2006
Boat: 2007 MC X2, RTP-1 5.7L 310 HP 1.5:1, 14.25 x 14.5 XMP OJ Prop, bimini, depth finder, and table, teak platform, White/viper red
Location: Pacific Northwest
Posts: 1,601
Ballast pump impeller change

I recently checked my impellers for wear and tear and wanted to show how it was done with pics as that always helps me. This was on an 07 X2.

First locate the rear ballast pumps in the rear cargo areas behind the back wall carpet. Three screws hold in the back wall panel.



Once the wall panel is removed you will have access to pumps.



Remove impeller and replace with a new yellow if needed. They only go on one way so no worries. One thing to note is make sure the paddlewheels angle in the same direction counterclockwise all the way around it as the impeller is intentionally bigger then the space you are putting it into.



Mine was ok but this is it installed.


Last edited by Roonie's; 07-15-2008 at 01:44 PM.
Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -4. The time now is 06:33 PM.