#1
|
|||
|
|||
1998 Prostar190 - I need a back seat
Purchased my PS190 without a back seat years ago. It's was used as a demo boat for watersking. I am now wanting to build a rear seat similar to the factory specs. So it can be used for a rear sundeck as it was intented. Does anyone have build info, advice, and dimensions?
![]() ![]() |
#2
|
|||
|
|||
Here's a start... couldn't find the thread I was looking for...
https://www.google.com/search?q=site...r+seat+rebuilt |
#3
|
||||
|
||||
Here was my re-build
http://www.mastercraft.com/teamtalk/...ad.php?t=51252 |
#4
|
|||
|
|||
I just re-did mine as the aluminum honeycomb was trashed in one corner. I used 3/4" marine grade plywood, and coated it with polyester resin. I also screwed a piece of angle iron under the seat for additional support. It is more sturdy than the original, but weighs twice as much. If I had it to do again, I may not use marine grade plywood because you make about 5 of them with treated plywood for the same price. Here is a print I drew up from measurements of the original honeycomb seat:
https://dl.dropboxusercontent.com/u/...at/SUNDECK.pdf |
#5
|
|||
|
|||
Also, here is a link to my thread, though I didn't do a very good job actually documenting anything.
http://www.mastercraft.com/teamtalk/...ad.php?t=58106 |
#6
|
|||
|
|||
Thank you everyone. I am excited to start this project. Cheers!
|
![]() |
Thread Tools | |
Display Modes | |
|
|