View Single Post
Old 05-06-2012, 01:20 AM
pram's Avatar
pram pram is offline
Join Date: Mar 2005
Boat: 1995 Mastercraft Prostar 205
Location: Kelowna BC
Posts: 1,915
Send a message via MSN to pram
Originally Posted by Table Rocker View Post
What you are pushing against in the middle of the harmonic balancer is the crank trigger. The only hole in the middle is the hole the bolt goes through. You need to put the bolt back in the hole, but leave it sticking out about a 1/4", then use your puller. You might need to repeat the process a couple of times, but you will get the balancer and trigger off.

If I didn't make it clear, your puller will be pushing against the bolt.

That will pull off the balancer and the trigger. The balancer is held on to the trigger by the bolts from the raw water pump. The flange you stripped the bolts in is the front of the trigger.
This would have been my suggestion as well that you needed to have the bolt in
I live in my own little world. But it's OK - They know me here

Reply With Quote