View Single Post
Old 06-20-2013, 07:49 AM
hig's Avatar
hig hig is offline
TT Enthusiast
Join Date: Apr 2013
Boat: 1998 Mastercraft Maristar with a Corvette LT1
Location: Northeast
Posts: 173
Originally Posted by Greenster View Post
You are doing a great job. Nice to see a Mastercraft restored.

As far as your water pump thermostat. You will need to order one. A marine boat 160 is different from the chevy one. Dont forget to get the seal for it as well. If I remember right, I got mine from Skidim
Originally Posted by mtajpa View Post
My sender is still reading acurate. Thanks for the pat on the back Frank. Is it possible that the Relay/Buzzer is for the check engine buzzer that comes on when you first turn on the ignition?

Great progress by the way. Mine started out similar to yours however mine was running well just needed the elbow grease part. Keep up the good work.
Thanks for the compliments on the boat. It's been a lot of work but I'm getting excited that it's going back togeter now!!

I'm working on an order from Skidim, fuel gauge sender, raw water impeller, t-stats, gasket & o-ring.

Does the boats have a factory installed buzzer? The one I took the picture of was definately not "factory" installed, it was held on by one screw and the wires were not run thru wire loom like the rest.

Thanks again, Steve
My progress thread: 1998 Maristar 200 VRS
Reply With Quote