View Single Post
  #9  
Old 12-23-2011, 02:25 PM
jkski jkski is offline
MC Devotee
 
Join Date: Jun 2005
Boat: 2008 40th Anniv. Prostar 197 MCX and Powerslot
Location: Akron, Ohio
Posts: 2,131
OK, so the job just got a little easier as I looked at the lights and the holes are already there for the bulbs (either factory designed or previous owner had a strobe kit on it).
So, here is my questions:
The bulbs are not non-LED and they came with a "thermal disc" that goes around the rubber housing for the bulb and gets mounted to the outside of the light assembly. The bulb fits the hole perfectly and is a nice tight fit without the "thermal disc" in place but if I put it on there I would have to use the 2 small screws they provide and attach the bulb to the housing. Can I simply replace the "thermal disc" with heat reflective tape and then utilize the silicone sealant to act as a glue to secure th bulb in place rather than add 2 more small holes?
Let me know what you think.
Reply With Quote