View Single Post
Old 01-01-2013, 04:32 PM
jkski jkski is offline
MC Devotee
Join Date: Jun 2005
Boat: 2008 40th Anniv. Prostar 197 MCX and Powerslot
Location: Akron, Ohio
Posts: 2,152
Thanks for the pic, that is exactly what I was thinking although I will have to do a little additional engineering due to the V plow configuration choices. I was thinking of making 2 seperate pieces and welding a nut on the the face of the end of each piece so I could simply tighten a bolt against the cutting edge and allow the pressure of that to hold it in place. I will take a pic after I do it, just need to buy the pipe first.
Thanks again for the pic.
Reply With Quote