View Single Post
  #5  
Old 04-24-2016, 09:28 PM
BrianS's Avatar
BrianS BrianS is offline
TT Enthusiast
 
Join Date: Jul 2004
Boat: '08 X14
Location: Dayton, OH
Posts: 452
Not sure if this will be helpful, but here is the wiring diagram for the MMDC and VDIG. It shows that the trim position signal should go to the MMDC. The VDIG has 2 connectors on the back, the main harness and the signal from the MMDC. I would make sure both are plugged in to the back of the VDIG. It will still show most values correct without the MMDC connection since it reads the info direct from the CAN bus.
Attached Images
File Type: pdf VDIG_wiring_diagram.pdf (200.0 KB, 106 views)
Reply With Quote