View Single Post
  #1  
Old 09-06-2013, 07:42 PM
Mark rsa2au's Avatar
Mark rsa2au Mark rsa2au is offline
TT Enthusiast
 
Join Date: Mar 2013
Boat: Mastercraft X5 2001. 310hp preditor
Location: Australia
Posts: 178
Strut angle adjustment??

Hi guys

Has anyone used washers or similar to place between the strut and the hull. Mine was bent straight but the angle holds the shaft just a little too low so it does not meet the coupling exactly flush. With the motor mounts at their lowest it is still out and not perfect.

While it works, there is still a vibration on pull off and if I can wedge the strut by about 2mm at the rear 2 holes, it will lift the shaft perfectly so that I can alighn the motor properly.

But will it do any damage to the strut or the hull?
Reply With Quote