View Single Post
Old 05-24-2012, 10:59 AM
Stx221's Avatar
Stx221 Stx221 is offline
TT Enthusiast
Join Date: Jan 2012
Boat: 1995 Prostar 190, LT1 w/ Powerslot
Location: Maine
Posts: 189
I have used JB Weld on a friends oil pan that had about a 2" crack or so in a car before. It held up for 2 years and about 20k miles with no issues. That was cheap cast aluminum and it held up very well, never leaked.

However, I wouldn't have done that to an engine block. I would pull the motor and either have it professionally welded and then pressure tested/rebuilt, or find a "junkyard" motor to put in its place.
Reply With Quote