View Single Post
  #85  
Old 11-26-2013, 10:05 PM
Wingnut Wingnut is offline
TT Enthusiast
 
Join Date: Aug 2013
Boat: 1998 M/C 205, 5.7 TBI
Location: Southeast
Posts: 150
Quote:
Originally Posted by Dynamite Spike View Post
What do you do about the busted honeycomb rear seat bottom? Mine is not broken, but it is bent due to people standing on it over the years. Does anyone know if this material can be reworked i.e. straightend
Several options - White Board or composite board- Both pretty expensive. Viper used 1 inch Plywood- fiberglass covered both sides and 3/4 x 3/4 aluminum square rod screwed into the bottom the entire width. A bit heavier but it seems to work- the aluminum honeycomb just snaps and crumbles when straightened. Some folks have made an additional center folding support that helps when people stand on it. Ill send a picture if you desire.
Reply With Quote