View Single Post
  #11  
Old 11-13-2013, 06:06 PM
Cloaked Cloaked is offline
MC Maniac
 
Join Date: Dec 2004
Boat: MasterCraft
Location: Kingston,TN USA
Posts: 4,601
Quote:
Originally Posted by bochnak View Post
Thanks for the response. The rear floor section is in good shape, so I'll leave it alone for now. I am missing some motorbox hinge screws as well as the gas shocks, which I will replace.

I do however, need to replace the front floor section near pylon. I'll follow your advice on rebuilding this portion.
So this setup still leaves you with an attached floor piece to the hood until you lift it out of the boat. Is that your intent? The nylon nuts or most others will not allow you to seperate the two pieces while in the boat. Just asking....it's jimmy crack corn to me...
__________________
93 190
.
Don't be a boot licker
.

Hose picture (internal) http://www.mastercraft.com/teamtalk/...68&postcount=8



Quote:
Originally Posted by Thrall View Post
..Some of you give a whole new meaning to the phrase "another @sshole with a Mastercraft."

RE: Thrall, Welcome to the club....
NEW SKINS in TN... Leading Edge Marine Interior

feedback on a TN company: http://www.mastercraft.com/teamtalk/...ad.php?t=58767

.
Reply With Quote