View Single Post
  #21  
Old 09-15-2013, 11:31 AM
LJN LJN is offline
TT Newbie
 
Join Date: Jul 2013
Boat: Mastercraft, maristar 210, 2000
Location: Southeast
Posts: 22
Havenít had a lot of extra time to work on the boat in last couple of weeks, but have been playing with the blasting cabinet a few minutes here & there.

Jsturvey, I actually found where the anode was supposed to be, but was all the way gone! That will be replaced after the tank comes back from the radiator shop from being tested. I imagine it is good as the antifreeze was very green & clean; surprisingly.

The next obstacle I am facing is the raw water pump is stuck on the pulley. I have tried wedging a chisel & blade between them & let them soak in penetrating oil for a week, but no luck yet. Anyone have any tricks to get this off?

I blasted a few of the brackets I have off already & had a friend down the street powder coat them with a stainless infused powder he hasn't used before. Best part is it was free.

Luke
Attached Images
  
Reply With Quote