View Single Post
  #15  
Old 08-14-2013, 07:18 PM
mallees's Avatar
mallees mallees is offline
TT Enthusiast
 
Join Date: Aug 2004
Boat: Matercraft X2 2004 350 MCX
Location: Melbourne Australia
Posts: 205
The standard 608zz bearing would do the trick. You would need to pin punch the shaft and apply some loctite retainer to hold the bearing place. These pumps only run for 5-10 mins at a time, so there is no real load on the bearing. The other problem i have is that the front motor end shield appears to have been machined slightly off-center, so there is a considerable side-load on the bearing.
Reply With Quote