Thread: Window tint
View Single Post
Old 08-01-2013, 09:25 AM
wakecumberland wakecumberland is offline
TT Enthusiast
Join Date: Mar 2008
Boat: 2010 X25
Location: Somerset, KY
Posts: 123

The frame is all attached with screws and compression fit rubber. There is a small amount of clear silicone adhesive in the joint between the two pieces of glass, most likely used to help with assembly. This is the order I went through for disassembly and was done on each side independently (duh):

1)Remove black rubber trim on exterior of frame base
2)Remove screws attaching frame to top deck
3)Lift windshield, frame still intact from the top deck and off the boat. (a second set of hands would be helpful)
4) Place windshield on carpeted surface and remove all screws from the frame
5) Remove top frame - I used some soapy water in a spray bottle to lubricate the rubber best I could. It tends to want to stick.
6) Remove bottom frame
7) Seperate the two glass pieces if it hasn't already

Hope that helps!
2010 X25 6.0
2015 MB B52 23
2011 X15
1955 Century Coronado
2006 X2
1968 Century Cheetah
Reply With Quote