'01 PS190- bolts have detached/unglued from top of throttle panel
I did some searching but only found references to throttle panels which have holes of some sort clear through the panel. On my '01 PS190 EVO, the bolts have a flat, thin head with holes in it, which is (was) glued to the inside of the panel. There are no holes through the top of the panel itself. The other day I noticed the panel sort of flopping in and out, and determined that the front two (of the three) bolts had broken off of the glue. I am grinding the remaining bits of glue ground off of the loose bolt heads. Wondering if I should try grinding or breaking the large "dabs" of glue off the panel, and reattach the bolts with some sort of epoxy? Any special type? All advice much appreciated.
2001 ProStar 190 EVO, LTR 330