View Single Post
Old 05-06-2013, 12:22 AM
thatsmrmastercraft's Avatar
thatsmrmastercraft thatsmrmastercraft is offline
MC Master Poster
Join Date: Sep 2008
Boat: 1977 Stars & Stripes
Location: St. Paul, MN
Posts: 16,819
Originally Posted by View Post
Some times when installing EI the plate that mounts shifts some from where #1 originally was. I would remove safety lanyard, then remove #1 spark plug bump starter over until compression comes up then verify where rotor is pointing. BTW which EI kit did you install. If it ran fine before installing this kit especially without messing with idle air mix screws than it's something with your EI. Theoretically #1 can be pointing at any post on cap as long as its on TDC at the same time.
Good answer, sir.

Two Chrome 10 hole wheels with Kenda Loadstar radials.
Mounted, balanced & delivered.
With ST205/75R14..........$309
With ST215/75R14..........$346

CARBURETOR REBUILDING - $199 Parts, labor & return shipping included
Holley Marine 4160 Freshly Rebuilt $349 - Delivered (no core charge)

Originally Posted by Bouyhead View Post
Installed my carb that was rebuilt by thatsmrmastsercraft, Thanks Peter!! Hot or cold this boat starts and runs like it fuel injected.
Reply With Quote