View Single Post
  #58  
Old 04-29-2013, 01:37 AM
tim79mc tim79mc is offline
TT Regular
 
Join Date: May 2012
Boat: 1979 Stars & Stripes
Location: Northeast
Posts: 89
Started cutting pieces for the floor and ordered a bunch of parts today. Measured 4 times, cut once, prayed and thankfully fit was spot on. At $100/sheet for this marine ply, I'm not ready to screw up...

I test fit the engine and it looks good. Made sure I understood the clearances needed for floor / exhaust, etc. I did find that the cradles I made for the exhaust were just a little bit too high, so modded those. Good to find before I installed the floor.

Warm enough for shorts and skiing today if the boat were ready...
Reply With Quote