View Single Post
Old 04-25-2013, 12:19 PM
Wouter's Avatar
Wouter Wouter is offline
TT Enthusiast
Join Date: Jan 2007
Boat: Mastercraft Prostar 190, 1990, Indmar Ford 351w GT40P, Borg Warner 1/1 Velvet drive 71c 10-17-004, pp stargazer, Acme 13
Location: Belgium
Posts: 257
Remove the rest of the clutch plates (stage in order)
When you have removed pressure plate 71, check if you have a snap ring that separated it from the ring gear (69) (b/w pressure plate and ring gear.) This snap ring normally sets the clearance of the clutch pack. Some models transmissions have this snap ring, some do not according to the experts on this forum. Mine does not.
When you receive your parts you can give the clutch plates a 24h bath in atf fluid.
Attached Images

Last edited by Wouter; 04-27-2013 at 04:30 AM.
Reply With Quote