View Single Post
Old 04-23-2013, 12:57 AM
Rossterman's Avatar
Rossterman Rossterman is offline
MC Devotee
Join Date: May 2012
Boat: 2001 prostar 205V
Location: Westcoast
Posts: 1,069
Originally Posted by thatsmrmastercraft View Post
Care to give a description of this method?
1. Using two strong magnets, tape the first one on the inside of the hull where the fittings, elbows, etc have enough clearance to assemble.

2. Go under the boat and move the magnet around until it is attracted to the one inside the boat. If location is ok on the underside as well. Mark the spot to drill. I had to go under the boat a few times to adjust locations but worked out perfect.

Can't believe someone hadn't thought of this earlier. Wakemakers mentioned it when i was buying the ballast parts and also mentioned the fact that they have a utube video online showing how to do it.
Reply With Quote