View Single Post
  #4  
Old 04-15-2013, 11:48 PM
wheelerd's Avatar
wheelerd wheelerd is offline
MC Devotee
 
Join Date: Dec 2007
Boat: 2005 X2
Location: Central Alberta, Canada
Posts: 1,212
Technically possible on most any boat I would think. There are two basic manufacturers -- Bennett and Lenco. There's a thread here about the pros and cons of each: http://www.mastercraft.com/teamtalk/...ad.php?t=34579

I have a Bennett unit that I'm planning to install on my 05 X2 later this spring. I have direct interior access to where the actuators will mount on the transom since I have a Vdrive. Not sure about your Ddrive. Then it's just a matter of finding a convenient spot for the hydraulic pump. My only small issue is that my transom is slightly curved so I will have to shim the mounting plate just a bit at either end next to the exhaust outlets.
__________________
"For every complex problem there is an answer that is clear, simple, and wrong." (Henry Louis Mencken)
2005 X2, Viper Red, MCX, OJ TZ-X5 prop, PPass, rear 750 sacs, KGB, IBS, Bennett Wake Plate, custom wake gate
(previous) 2001 X5, 1991 TriStar 190
Reply With Quote