Thread: Bow hook issue
View Single Post
  #25  
Old 04-14-2013, 03:16 PM
mikeg205's Avatar
mikeg205 mikeg205 is offline
Moderator
 
Join Date: Aug 2011
Boat: 1995 Pro Star 205 5.7 Liter
Location: Plainfield - Joliet, IL
Posts: 10,405
Send a message via Skype™ to mikeg205
Quote:
Originally Posted by SKI*MC View Post
So I've been doing some work for the past 2 weeks. Here's some pictures of the work that was done. In the first pic, was the bow with all the hardware taken out. I sanded the area and cleaned it up a little. Next one is of a thick new layer of bondo-glass over the old broken pad. The third pic is of a quarter inch thick steel backing plate I made the covers the entire length and width of the new pad. The forth pic is with all the hardware back in all tightened down. I also added a plate to go on top of the lifting ring bracket, I figured it couldn't hurt anything.The last pic is of the outside. A stainless backing plate with a brand new u bolt welded to it. I still have to trim the excess rubber, but I think I can finally cross this project off the list.
Nice work...
__________________
...A bad day water skiing still beats a good day at work...1995 Pro Star 205....
Reply With Quote