View Single Post
  #27  
Old 04-01-2013, 09:00 PM
JimN's Avatar
JimN JimN is offline
MC Master Poster
 
Join Date: Jul 2004
Posts: 11,349
Quote:
Originally Posted by Jerseydave View Post
I know, both are new and the engine does get warm at the pipe plug location in the left cylinder head (as checked by an infrared heat gun). I feel this is where my sensor should be, not at the mixer in front where constant cold water enters. Not sure why it's there, but I really should relocate it to the cylinder head to see if I get a more steady temp reading. Maybe the owner before me put it there, not sure.
Is that the one wire sender or the two wire sensor? They go where the harness reaches and where it was located from the factory.
Reply With Quote