View Single Post
  #3  
Old 03-21-2013, 11:46 PM
j.mccreight@hotmail.com's Avatar
j.mccreight@hotmail.com j.mccreight@hotmail.com is offline
MC Maniac
 
Join Date: May 2010
Boat: 1989 MasterCraft TriStar 190 SE
Location: Houston, TX
Posts: 2,906
Quote:
Originally Posted by sgoyal View Post
I am planning to start the LED CupHolder Rings project (just for fun right now) and can someone tell me what's the inside diameter for Mastercraft boat. I was planning to cut 3 3/4 and 3 5/8 inside diameter and add 1/2" to it.I haven't set the selling price (or even calculated my cost) and was wondering how much is the reasonable price you guys think should be. I don't want to spend time if most of the consumer thinks it's an expensive.

I'm planning to use 1/4" or 6mm sheet for that.
I think this should be a starting point
http://www.bulletlines.com/LED-Cup-H...Rings-s/43.htm
__________________
James

1989 MasterCraft TriStar 190 SE
Reply With Quote