View Single Post
  #17  
Old 03-19-2013, 03:45 PM
Jerseydave's Avatar
Jerseydave Jerseydave is offline
TT Hero
 
Join Date: Jul 2004
Boat: 2005 X-STAR & 1993 Prostar 190 Limited
Location: Jersey
Posts: 5,392
Quote:
Originally Posted by GoneBoatN View Post
Two plugs in the block (one each side), and disconnect the hose that runs between the manifolds/risers.
One side of the engine will likely have a knock sensor not a plug, just remove that and make sure water pours out of both sides of the block. Disconnect hose as stated above. You should pull the impeller after cranking the engine over to drain water from that area as well.

Where are you in VA, Lake Anna?
Nice boat.....Welcome to the X-star club!
__________________
I was njskier on here.
Reply With Quote