View Single Post
Old 03-15-2013, 07:36 AM
CantRepeat's Avatar
CantRepeat CantRepeat is offline
Join Date: Jul 2008
Boat: No Boat
Location: Roll Tide!!
Posts: 14,795
Originally Posted by homer12 View Post
I am in the processing of just doing the seal on mine. The bearings seem totally fine. I have the shaft and bearing out and was able to put the pump upside down in the bench vice with the flange on the housing against the vice and pound out the shaft. I used a hammer and a solid round piece of stainless I had about the same diameter as the shaft. Will post pics when I get done.
For future reference I would recommend a brass drift or punch if you are going to use the hammer method to extract the pump shaft. Using a softer metal drift will have a lesser chance to damage the shaft when compared to a SS drift.

"Heavy" beer is for wine drinkers that are too embarrassed to drink wine in front of their buddies. "Light" beer is a drinkin' man's beer!
Reply With Quote