View Single Post
  #9  
Old 03-12-2013, 11:01 PM
Table Rocker's Avatar
Table Rocker Table Rocker is offline
MC Devotee
 
Join Date: Oct 2010
Boat: '96 ProStar 205, Sammy Duvall, LT-1
Location: Fayetteville, Arkansas
Posts: 1,600
Quote:
Originally Posted by Tristarboarder View Post
It has the caps on the outside of the bracket that holds the pin. They, as most of you know, are a "hat" shape. How are they removed? Looks like they are pressed on. I tried prying with a screw driver, but I didn't want to break it or bend it up. It did give a fight as is while I pulled on them. So, any suggestions on how to remove the end caps holding the roller on? Thanks.
My experience has been to pry them off with a big screwdriver and replace them. I doubt you can get them off in reusable condition. I'm not sure of the size you will need, but most hardware stores will carry them.
http://www.lowes.com/pd_65291-37672-...nut&facetInfo=

Looking good with the project.
__________________
'96 ProStar 205 SD LT-1
Reply With Quote