Originally Posted by east tx skier
I had the same thing done on mine. I have a Faria Depth Finder/Air/Water Temp Sensor. I ran the wiring for my water temp sensor through the tubing hole for the pitot pickup on the starboard side. Or, I should say, the mechanic who installed it for me did. I got a special sized thru-hull (not in-hull) depth finder pickup that fits the 2" hole from my old (no longer used) Perfect Pass paddle wheel. The depth finder pickup is flush mounted through the hole.
Air temp sensor is just tossed up under the dash.
You have part numbers for this (gauge and xducer)? I have an unused opening in my hull just to the port side of the drain plug. This was used by the PO for the suction side of his ballast pump. Would this be too far forward on the hull to read while at speed?