View Single Post
  #19  
Old 02-28-2013, 06:28 PM
SKIBUMM SKIBUMM is offline
TT Enthusiast
 
Join Date: Aug 2009
Boat: 1994 Falcon
Location: Southwest
Posts: 188
Good question as I have never done it but there would be a couple of ways. first you need to make sure your boat is level to begin with I would suspect that is the critical part. Then measure down at diffent locations throughout and then transfer that measurements. Or you could mark one point and if the boat is perfectly level you might be able to use a laser transit to find the other locations too. If you are redoing the stringers they are the important part ot make sure they are put in level and true then the floor should be easy(so to speak) at that point.
Reply With Quote