View Single Post
  #14  
Old 02-26-2013, 08:06 PM
SWGA Boater's Avatar
SWGA Boater SWGA Boater is offline
TT Enthusiast
 
Join Date: Oct 2012
Boat: Not a MasterCraft
Location: Southwest Georgia
Posts: 203
Right now I am using a 4.5 inch grinder with a 36 grit flap wheel. Will also need something a little smaller to get in the tight spaces. If you had a 7 inch that would work good for the larger sections. I probably will go back over this with a 100-150 grit paper on my palm sander to clean it up. The 36 grit will really take off the glass depending on the pressure you use. Here is how far I am along. You can see where I have gotten to in the last picture.



Reply With Quote