View Single Post
  #23  
Old 02-02-2013, 01:13 PM
mccobmd's Avatar
mccobmd mccobmd is offline
MC Devotee
 
Join Date: Apr 2007
Boat: Mastercraft X1 2006 310HP
Location: Oklahoma
Posts: 1,035
Here is th 1/2 inch poly board that I cut to match the divider. Put holes through it and countersunk the screws with sunken washers on the sac side and locking wing nuts on the other side all stainless steel. The second picture is with hard tank out and 750 sac empty. As on other poster said with a one way valve it will suck the sac dry. The last is with it full. There is the same clearance to the manifold as if it was empty.
Attached Images
   
Reply With Quote