View Single Post
  #8  
Old 01-20-2013, 07:19 PM
JaredOSU JaredOSU is offline
TT Regular
 
Join Date: Jun 2012
Boat: Mastercraft Prostar 190 351 Windsor 1:1 Borg Warner
Location: South Central
Posts: 41
I bent the prop pretty badly when I hit the ground. I was going slalom speed and hit ground a little beyond the last gate. I was on a course & lake that I ski down once every few years in eastern oklahoma. And at the start of last season I noticed some noise near the prop shaft seal. I called SkiDIM and they said that the shaft was likely bent. So I replaced the drive shaft and seal. I took extra-special care to make sure I lined the engine and drive shaft to less than .003". So I replaced everything but the cutlas bearings. I even put a brand new steering system in the boat.
Reply With Quote