I have been off on winter break for three weeks... This was not all done today, but throughout the time. Just got time to throw up some pics tonight.
1) pulled off platform and compounded the transom because it was oxidized. Still not perfect, but much better.
2) pulled up floor panel to grease and clean stearing cable and cleaned bilge while in there.
3) went to clean up motor area a bit and decided to pull the pulleys and pain them with high gloss engine enamel.
4) cleaned and began applying coats of teak oil to platform. At 4 coats, would like to throw on a few more before spring.
All in all a lot of little things got accomplished over the break. Almost ready for spring.