Originally Posted by mxhideout
Anyone else? Or am I just going to have to make some calls to local shops?... Anyone gotten work done by Propulsion Inc.? (Propfix.com)
If the bend is at the tip of the shaft at the prop end, you are probably not going to be able to have it straightened close enough to the .002" run out tolerance that is recommended. I ran over something with my father in law's MC years ago, bent the prop and shaft up and investigated having it straightened. Contacted a company (in NC I believe) that another member had used to straighten a bent shaft, and when I told them where it was bent, they said it wasn't going to be something they could fix properly.
New shaft from skidim, refurbished prop, some glass work, and I was good to go.
Previous: 1993 Prostar 205
Red 1998 Closed Bow Ski Boat, PCM GT40, 310 hp, Standard Gear Reduction, Acme 4 blade, Perfect Pass SG/Zbox.
Tyler Ski Club
Be kind. Have fun.